AAP3798102-00130 控制模块 缩小内部能力差距

AAP3798102-00130控制模块
AAP3798102-00130通用显示压缩机控制模块便用通用接线板或接线板将接线板安装在控制外壳内，并将屏蔽电缆从接线板连接到模块接线板端子上的每个输入电路。Y将每根电缆的屏蔽连接到接线板旁边的金面板。不要在模块端连接屏蔽(在电缆模块端切断屏蔽并用热缩管绝缘)。Y用屏蔽电缆将现场设备连接到端子板，AAP3798102-00130仅在设备端接地屏蔽(在电缆的端子板端切断屏蔽并用热缩管绝缘)。此外,应尽可能缩短端子板和设备端的外露(屏蔽外部引线的长度、直接方法Y将新电缆从现场设备传感器，电位计)直接连接到模块。Y将导本连接到模块端子板上的话用钉上。将现场设备端的屏蔽接地，使最小数量的导体暴愿在噪声环境中。

AAP3798102-00130

AAP3798102-00130 Control module
Aap37998102-00130 The universal display compressor control module then mounts the patch board inside the control housing with a common patch board or patch board and connects the shielded cable from the patch board to each input circuit on the module patch board terminals. Y Connect the shield of each cable to the gold panel next to the patch panel. Do not connect the shield at the module end (cut the shield at the cable module end and insulate it with a heat shrink tube). Y Connect the field device to the terminal board with a shielded cable, AAP37998102-00130 grounding the shield only at the device end (cut off the shield at the terminal board end of the cable and insulate it with a heat shrink tube). In addition, the exposure of the terminal board and device end should be reduced as much as possible (shielding the length of the external lead, direct method Y to connect the new cable from the field device sensor, potentiometer) directly to the module. Y Fasten the guide to the module terminal board. Ground the shielding of the field device so that a minimum number of conductors are exposed to noise.

AAP3798102-00130

其他型号推荐：

AAP3798102-00130